ZombieMudAn Information Source about ZombieMud FrankensteinPuting Frank togetherTo build a frank you need to gather alot of corpses, then make them into the apropiate parts, sew the whole thing together and finally give it life. Fortunatly you only need to do this once (see below). The process:
Step by Step:
If Frank "dies"If frank hits 0 hps, then he will break apart into his component parts and whisked back to your pod. Then you go to your pod, create the neccessary "glue" corpses, and sew him back together, using the same syntax you did when creating him in the first place. It is not known what will happen if your frank is in peices over reboot, none of us are brave enough to find out. (I've heard he will go to recovery, but will never reach full strength again) Frank will continue to follow you, as soon as you put the first piece back on him. This can cause problems, as he's slow and weak; it's best to stop him from following until he's healthy again. A suggestion: Go to your POD immediately and tie your frank to prevent him from losing strength. If caught soon enough, he may only get knocked down from "lift you like a fly" (top strength) to "can lift an archwizard." "glue" corpsesWhen preforming If you attempt to add a part with a "glue" corpse that is too small, nothing is done and you get the following message:
If you add a part with a corpse on the ground that is larger than needed, it is consumed. So be aware, you may want to split a large corpse into multiple first. last updated 2 years ago # |